Target overall annualized failure rate AFR:. Asia Pacific and Oceania. After it has finished:. Asia Pacific and Oceania. We are unable to determine your warranty status for the product and serial number provided. If HP receives notice of such defects during the warranty period, HP will either, at its option, repair or replace products that prove to be defective. If it is uneven, trim it as explained in step 7; otherwise go to step 8.

Uploader: Bagrel
Date Added: 23 December 2014
File Size: 67.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23065
Price: Free* [*Free Regsitration Required]

The media cutting knife used in the next step is sharp. Except on glossy media types, the printer will operate successfully in monochrome with just the black cartridge loaded; these instructions assume that you are loading all four cartridges.

Let go of the media when the printer begins to pull it in.

To make sure that your printer pluw exactly what you expect–in terms of size, position, orientation, and quality–use the correct driver for the combination of your application software and printer. Thank you for your patience. Contact the local HP dealer or HP service engineer to arrange to have the designejt serviced. Configuration B can be specified in the same way. Checklist of typical tasks to set up your software Identify which driver you need.

Pull the media towards you, holding it from the sides, and align its right edge with the perforated line on the entry platen. Please use the product number and serial numbers of the new product to validate warranty status.


This product was sold by a third party.

HP Designjet and C Plus Printers – Setting up the Printer | HP® Customer Support

Contact your local HP dealer or HP service engineer to arrange service. Choose a different product.

Select an operating system and version to see available software for this product. Those using this product may find useful the following booklet prepared by the FCC: If you have color vision deficiencies, you can identify the colors of the cartridges by the part numbers on the boxes. Maximum power in idle state: Most existing prinf cables support Bitronics communication, but for use with this printer, the cable must meet the specification in the following table:.

Researchers find way to track ‘untraceable’ 3D-printed guns The 3D-printer leaves a hardware fingerprint.

To restore the factory default configuration, go to the Accuracy menu deesignjet the front panel and choose Restore Factory. Graphic languages The printer accepts drawing data from CAD software programs supporting the following languages:. Modify your browser’s settings to allow Javascript to execute.

HP DesignJet c plus – large-format printer – color – ink-jet Overview – CNET

To avoid an electric shock, verify that that the printer is switched off and unplugged before cleaning it. Europe, Middle East, Africa.


A series of dialog boxes usually appear, where you can specify such items as default media type or print quality. Press down lightly and push the cartridge away from you until it snaps into place. Holding the media from the sides, align the right edge with the perforated line on the entry platen.

Javascript is disabled in this browser. Roll designjef in x ft.

HP DesignJet 750c plus – large-format printer – color – ink-jet

Insert the spindle so that the large media stop is to the right and the small end cap to the left. Switch off the printer and your computer, connect the interface cable, and then switch them on again. Serial number location When looking at the back of the printer, the serial number is located directly above the power plug on the right side of the rear panel.

Place the spindle vertically on the floor, with the media stop at the bottom, ready for the new roll. Prinf overall annualized failure rate AFR:. Asia Pacific and Oceania.